Cannabinoid products without terpenes are simply not the same. However, adding terpenes is a skill that takes a lot more than trial and error. You will need to understand the basics of cannabis terpenes mix and how to use a terpene mixture calculator to help you add terpenes into your products. Continue reading to learn how to enhance your products using terpenes.
How Do You Make Terpenes Mix?
Oil is usually the best form of high-quality terpenes. Combining terpenes and cannabinoid extracts is easy because most of them are oil-based.
The process of terpene mixture can be more or less complicated depending on what product you are trying to boost with bulk Terpenes. For example, it is easiest to add terpenes into vape concentrates made up of Cannabis Sativa flowers extract.
What are the Drops of Terpenes in a Gram
This depends on the potency and consistency of the oil. 20 drops of water per gram, oils behave differently to water. Sometimes, 20 drops might weigh only 0.5 grams. Other cases might see 20 drops of Terpenes weighing 1.5 grams. Therefore, you shouldn’t measure terpenes as drops. Instead, measure terpenes in grams or milliliters.
What is A Terpene Diluent, You Question?
A diluting substance is one that is used for diluting a solution. Terpene diluents are available from some terpene producers. These can be used to liquefy isolated extracts or dilute winterized extracts.
Low-quality terpenes requiring diluents are common. Worse, terpene-based diluents often contain vegetable glycerin or propylene glycol. It’s simple to add terpenes accurately to your product formulation by doing some basic calculations. Here are the basics:
- Your formulation’s starting weight in grams
- You can specify the percentage of Terpenes that you would like to see in your final formulation
- You can specify the percentage of any diluents that you would like to add to your formulation
A simple calculation can help you determine how many grams of terpenes are needed to make your formula.
- Let’s say your current formulation weight (W), is 100 grams
- The desired concentration of terpenes (T) should be 3%
- You need to add approximately 0.1 T (W). + 0.1T 2 (0.01W).
- This means that you will need to add 3.09 grams of terpenes into your product formulation.
- The final formulation will weigh in at 103.09g
Wholesale terpenes are usually measured in volume and not weight. You can measure the weight of terpenes in milliliters by placing a small amount of concentrated terpenes in another container. Then, place that container on a scale. Milliliters cannot be converted into grams directly. Although 1ml of water equals 1g, other substances have different densities. This results in different milliliter to gram ratios.
What is the good percentage of terpenes?
Cannabinoid products shouldn’t contain more than 15% of terpenes. In most cases, the final product formulations should contain between 2-5% of terpenes. Low terpene levels below 2% may not give you the aroma and flavor benefits that you want. However, products containing more than 5% of terpenes might have a strong terpene smell or taste.
Are All Terpenes One?
Terpenes have been most prominently known for their roles in Cannabis Sativa. But, they can also be found in many other plant species. Have you ever wondered what makes lemon peels so fresh? It’s the Terpene Limonene. What about the pine needle scent? It is caused by the terpene Pinene.
A terpene that is found in cannabis has the exact same chemical composition as one found in another plant. However, terpenes made from cannabis may contain trace amounts of other substances in the Cannabis Sativa plant.